Unfold the remote controller’s left mobile device clamp. Pull out the cable’s connector from the Micro-USB port on the left side. Push out the other connector from the RC cable slider to completely remove the wire. Push the slider frame out by pressing on it from inside. A new slider needs to be mounted from the outside of the left clamp. Position the slider so the grove is facing inside. Place the lower part of the slider into the frame. Press down the upper part to mount the slider. Mount the RC cable’s connector to the slider from the inside of the clamp. Insert the other connector into the Micro-USB port and slowly press down the wire to the cable slot. The RC cable is now replaced
DJI Mavic Pro – How to Replace the RC Cable and Slider
Recent Articles
-
DJI Mavic - RTH Logic
During a flight, RTH can be triggered by...
-
Mavic Tutorials- IMU Calibration
This video will show you how to calibrate...
-
Mavic Tutorial Video - How to Charge the Remote Controller
This video will show you how to charge...
-
DJI Mavic Pro - How to Install the Mobile Device
The DJI Mavic Pro is a small yet...
-
DJI Mavic Pro – Exporting Remote Controller Data with DJI Assistant 2
In this video we will show you how...
