Unfold the remote controller’s left mobile device clamp. Pull out the cable’s connector from the Micro-USB port on the left side. Push out the other connector from the RC cable slider to completely remove the wire. Push the slider frame out by pressing on it from inside. A new slider needs to be mounted from the outside of the left clamp. Position the slider so the grove is facing inside. Place the lower part of the slider into the frame. Press down the upper part to mount the slider. Mount the RC cable’s connector to the slider from the inside of the clamp. Insert the other connector into the Micro-USB port and slowly press down the wire to the cable slot. The RC cable is now replaced
DJI Mavic Pro – How to Replace the RC Cable and Slider
Recent Articles
-
Mavic Pro - Entering Wi-Fi Mode
Mavic Pro, entering Wi-Fi mode. Open the SD...
-
DJI Mavic Pro – How to Replace the RC Cable and Slider
Unfold the remote controller’s left mobile device clamp....
-
Linking the Remote Controller without DJI GO 4
Mavic Pro, linking the remote controller without the...
-
Attaching the Gimbal Clamp
Mavic Pro, attaching gimbal clamp. With the Mavic...
-
DJI Mavic Pro – Attaching Propeller Guards
Mavic Pro, attaching propeller guards. Check the letter...
