Skip to next element
Free shipping over $599

DJI Inspire 2 | Mounting the Gimbal Protection Set

DJI Inspire 2 | Mounting the Gimbal Protection Set

Inspire 2, mounting the gimbal protection set. To avoid the Zenmuse X7 gimbal coming off due to an aged or loose gimbal dampers it is recommended that you mount the Inspire 2 gimbal protection set to the gimbal vibration absorbing board. Place the buckle fixing base to the raised part in the gimbal vibrating absorbing board’s mounting slot and ensure that it is locked firmly. Pre tighten the 2 screws with a T8 screwdriver. Ensure that the buckle is placed firmly and then tighten the screws. Remove the 2 fixing screws on the bottom of the aircraft take a screw from the gimbal protection set and insert it through one of the loops on the end of the steel cable and then tighten the screw to the bottom of the aircraft. Perform the same steps to mount the other screw. Check whether all the screws are tightened firmly. Move the vibration absorbing board to ensure that the gimbal protection set work normally.

Share on: