DJI Inspire 2 - Linking the Aircraft and the Remote Controller

This video will show you how to link your Inspire 2 with its remote controller.  All Inspire 2 remote controller are linked to the aircraft before delivery. But if the aircraft status indicator flashes yellow quickly and the indicator on the remote is solid red the remote controller needs to be linked to the aircraft. There are 2 ways to link the aircraft with the remote controller. 1. Linking RC with DJI Go 4. Connect the remote controller to the mobile device. Power on the remote controller and the aircraft. Launch DJI Go 4 and press the RC icon in the top of the screen to enter the remote controller settings. Then select linking controller. The remote controller will beep and the indicator will flash blue indicating that it’s ready to link.  The RC will be primed to link for 60 seconds. Press the pair button on the front of the aircraft. The linking status indicator will flash red quickly. Linking is complete when the pair button and remote controller indicator turn green. 2. Linking without a mobile device. Power on the remote controller and the aircraft. Then press the C1, C2 and record button at the same time. When the remote controller starts beeping press the pair button on the aircraft. Ensure that the firmware of the aircraft and remote controller is upgraded to the latest version. It is recommend to upgrade to the latest firmware. If the remote controller is in slave mode linking will not work. Please set the remote controller to master mode. If linking fails reboot the aircraft and try again. If linking fails repeatedly please contact DJI support.