Inspire 2, replacing the gimbal dampers. Replace the dampers if they are damaged not flexible or cracked. Remove the dampers’ fixing pieces in the forward visions bracket with a Phillips screwdriver. Remove the 3 dampers from the gimbal vibration absorbing board. Do not damage the gimbal quick release port data cable. Mount the new dampers to the gimbal vibration absorbing board. Pay close attention to the installation direction. Ensure that the dampers are mounted in place. Mount the fixing pieces. Pull out the vibration absorbing board and check whether the dampers are firmly attached. Trim off the excess part of the dampers. If they’ve been used 120 times or more than 40 hours it is recommended that you replace the dampers.
DJI Inspire 2 - Replacing the Gimbal Dampers
Recent Articles
-
How to Adjust the Inspire 2 Landing Gear´s Position Manually
How to Adjust the Landing Gear’s position manually?...
-
DJI Inspire 2 - Activating the Inspire 2
This video will show you how to activate...
-
DJI Inspire 2 - Linking the Aircraft and the Remote Controller
This video will show you how to link...
-
DJI Inspire 2 - Upgrading Remote Controller Firmware
This video will show you how to upload...
-
Mounting a 1550T Quick Release Propeller
Press down the spring pads on both aides...
