Skip to next element
Free shipping over $599

DJI Osmo Raw - Connecting the Wired Video Adapter

DJI Osmo Raw - Connecting the Wired Video Adapter

This video will show you how to connect to the Osmo Raw wired video adapter. These steps also apply to the Osmo Pro. Take note of the following information before connection: 1. The Osmo Raw wired video adapter only supports the Zenmuse X5 and Zenmuse X5R. It cannot be used with the Zenmuse X3 or Zenmuse Z3. 2. The Osmo Raw wired video adapter is incompatible with ISO devices due to an ISO system limitation. The Osmo Raw wired video adapter needs to be used with Android v4.4.0 or later and DJI Go v3.1.5 or later. Also Osmo Raw firmware needs to be upgraded to v1.4.0.70 or later. Connecting the Osmo Raw wired video adapter without the DJI Focus handwheel. With the Osmo Raw powered off connect the communication port on the wired video adapter to the communication port on the X5 adapter. Connect the USB port on the wired video adapter to your mobile device using an appropriate cable according to your mobile device’s port. After connection power on the Osmo Raw and launch DJI Go. If DJI Go and DJI Go 4 are installed on the mobile device use DJI Go. Connecting the Osmo Raw wired video adapter with the SJI Focus hand wheel. After the USB port on the wired video adapter is connected to your mobile device connect the wired video adapter to the communication port on the DJI Focus hand wheel with a dedicated communication cable. The USB cable needs to be purchased separately based on the DJI Focus hand wheel mode. Power on the Osmo Raw and launch DJI Go. If DJI Go and DJI Go 4are installed on the mobile device use DJI Go

Share on: