Skip to next element
Elevate Your Operations with Enterprise Drone Solutions

DJI Matrice 600 - Mounting the Remote Controller Channel Expansion Kit

DJI Matrice 600 - Mounting the Remote Controller Channel Expansion Kit

Matrice 600 mounting the remote controller channel expansion kit. The remote controller channel expansion kit is compatible with the Matrice 600 series remote controller which incudes 8 knobs or switches. Removing the interface module from the remote controller. Remove the 4 screws on the interface module with a 1.5mm hexagonal socket screwdriver. Remove the SDI port cover. Use the special wrench on the package to rotate the metal fixing rings on the SDI port counterclockwise. Remove the metal fixing ring and plastic fixing ring as shown. Remove the external shell of the interface module. Remove the 2 screws on the internal PCB board with a Phillips screwdriver. Unlock the black buckles for the 3 flat cables and remove the 3 flat cables gently. Remove the PCB board. Mounting a new interface module. Mount the new OCB board to the remote controller. Connect the 3 flat cables and lock the black buckles. Do not twit the cables. Tighten he 2 screws. Mount the external shell of the new module and tighten it with the 4 screws. Connect the CAN cable on the channel expansion kit to the CAN port. Mount the channel expansion kit to the remote controller handle as shown. Turn on the remote controller and wait a few seconds. When the status LED on the channel expansion kit is solid green it can be used normally.

Share on: