Mounting the Zenmuse Z30 to the Matrice 600 Pro

This video will show you how to mount the Zenmuse Z30 to the Matrice 600 Pro.1. Connecting the gimbal cable and attitude cable. First remove the GPS module on the nose. Then remove the upper center frame cover. Do not damage the fan cable. Remove he fan cable. Remove the GPS module CAN cable. Disconnect the landing gear power cable. Remove the lower center frame cover. Pull the video gimbal cable through the designated outlet on the lower center frame plate and connect it to the gimbal port on the Lightbridge 2. Pull the gimbal attitude cable through the designated outlet on the lower center frame plate and connect it to the CAN port on the A3 flight controller GPS. Then connect the GPS CAN cable. Connect the fan cable. Mount the upper center frame cover and the GPS module. Finally mount he lower center frame cover and connect the landing gear power cable. 2. Mounting the Zenmuse Z30 gimbal mounting plate. Secure the rear bracket and the 2 front brackets on the gimbal mounting plate with M3x5.5 screws. Connect the gimbal absorbing bracket and connectors. Pull the 3 rubber gimbal dampers though the holes on the connectors. Connect the gimbal flat cable to the flat cable port on the GCU. Connect the gimbal power cable to the DC-18V port on the PMU. Connect the video cable and attitude cable to the GCU. Mount the vibration absorbing bracket to the expansion tubes at the front of the aircraft. Secure the vibration absorbing bracket connectors with M3x8 screws. 3. Mounting the Zenmuse Z30. Remove the gimbal cap. Align the white dot on the Zenmuse Z30 with the red dot on the quick release port. Connect the Zenmuse Z30 to the quick release port. Rotate it until the red dot on the Zenmuse Z30 is aligned with the red dot on the quick release port. mounting is now complete.