This video will show you how to install a Zenmuse Z15-A7 gimbal onto the M600. Remove the center frame’s top cover and do not damage the connecting cable of the fan. Disconnect the power cable from the landing gear and remove the center frame’s bottom cover. Pass the Z15-A7 gimbal pin cable through the hole on the aircraft body’s bottom board and connect it to light bridge 2’s gimbal cable port. Place the Z15-A7 gimbal’s CAN cable through the hole on the aircraft body’s bottom board and connect it to the CAN port on the A3’s GPS. Connect the fan’s power cable and mount the center frame’s top cover. Mount the center frame’s bottom cover. Attach the Zenmuse Z15 gimbal connector to the Zenmuse Z15 gimbal (M3x6.5). Mount the gimbal’s connector to the specific inner mounting position with the connector’s opening faces outwards. Replace the original Zenmuse Z15 vibration dampers with the vibration dampers in the M600-Z15 accessory kit. Cut even each side of the vibration dampers. Move the Zenmuse Z15 to the central position and fasten the M3x8 screws on the connectors. Connect the gimbal’s CAN cable and video cable to the Zenmuse gimbal’s GCU. Connect 1 of the parallel power cable’s XT60 sockets with the power management board’s XT30 power cable. Connect the landing gear’s power cable to the parallel power cable’s XT30 socket. Connect the Zenmuse Z15 gimbal’s GCU power cable to parallel power cable’s XT60 socket. Arrange the cables. Zenmuse Z15 gimbal installation is now completed.
Matrice 600 Tutorials - How to installing a Zenmuse Z15-A7 gimbal onto the M600
By: Shopify API
Connect with Us
This video will show you how to setup...
Matrice 600 Tutorials - How to Mount the...
M600 Tutorials - How to Install D-RTK
Matrice 600 mounting the remote controller channel expansion...
This video will show you how to install...